We research in-depth and provide unbiased reviews and recommendations on the best products. We strive to give you the most accurate information. If you buy something through our links, we may earn a commission.
Before hanging wallpaper, you need to prepare the wall for it. Repair any holes and clean the surface. Choose a starting point in a corner of the wall that will be less visible. This way, you can hide the seam of the wallpaper behind a curtain. Once the walls have been prepared for the wallpaper, you can now begin hanging it. If you are unsure how to hang the wallpaper, here are some tips. The following steps should guide you through the entire process.
Preparation
Before you begin installing new wallpaper, it’s important to properly prepare the wall surface. Doing so will make the job easier and give you the results you want. Read the manufacturer’s instructions carefully to ensure the job is done correctly. Be sure to disconnect electrical wires before hanging wallpaper and make sure the wall surface is dry, clean, and structurally sound. And make sure to wipe off any excess paint before hanging wallpaper. Here are some general guidelines for wall preparation.
Remove any loose paint or decor from the wall. If the paint is glossy, it should be removed by sanding it down to a dull surface before applying primer. If there are bumps or groves in the wall, you can fill them with wall repair materials. Apply wall liner as recommended by the manufacturer for the best results. Some wallpapers require additional priming of wall liner to adhere properly. Follow the instructions on the wall liner.
Before hanging wallpaper, check the surface for imperfections. Look for paint flaking or flecks. This means that the paint isn’t adhering properly to the surface. If this is the case, sand the walls with coarse sandpaper to remove the flaking. Also, use a good quality primer. Make sure the surface is dry before you hang the new wallpaper. If the wall has a rough texture, use a primer that will protect it from moisture.
Prepare the wall before installing wallpaper. If the walls are dirty or greasy, wallpaper will not stick. Old paint and wallpaper may also prevent the wallpaper from adhering to the wall. Clean the walls and remove any loose paint or dirt. Before hanging, you should also clean the wall with non-woven lining paper. A non-woven lining paper is a better option for those with textured walls. Besides, it will give you an even surface.
Using paste-the-wall method
Compared to paste-the-paper installations, the paste-the-wall method is much faster and easier to do. You can hang it straight from the roll, eliminating the need for a pasting table. The adhesive doesn’t expand as much when wet, and you can even overlap sections. The only downside to this method is that you can’t be certain when it will be dry enough to hang the wallpaper.
Before hanging wallpaper, you’ll need to prepare the wall. If you’re hanging wallpaper without wallpaper paste, you’ll have to prep the wall first. After preparing the wall, you’ll want to hang one length of wallpaper at a time. The wallpaper has special backing that will prevent it from expanding when it is wet, making it much easier to remove than standard paper. To avoid this, be sure to measure the length of wallpaper you want to hang.
Using paste-the-wall method to install wallpaper is easy, and it can be removed if you need to change your mind. Using a roller or a smoothing brush, apply the paste to the wall in thin, even layers. Apply the paste from the top of the roll to the wall, aligning the panel with the vertical mark. When finished, use a seam roller to flatten the seams.
To install wallpaper using the paste-the-wall method, you need to measure the length of your wall. Be sure to leave about 2cm of overlap on the ceiling and baseboard. Once you’ve cut the length of wallpaper, you can then begin pasting. To use paste-the-wall method, you need to measure the height of the wall and place a level against it. Once you’ve done this, unroll the rest of the wallpaper, lining up the patterns and using your cut length as a guide.
Corners
To get perfect, even edges when hanging wallpaper, make sure that you measure every corner carefully. Depending on how uneven the walls are, you may need to cut the wallpaper by an extra 25mm, leaving some of the width to turn onto the next wall. Once you have measured and cut the required length of wallpaper, you should carefully hang the finished product into the corner, allowing some excess to wrap around. To make corners as smooth as possible, use a wallpaper brush to gently smooth the corners with the excess.
Start by measuring the distance from the corner. Add half an inch to allow for the overlap, and then trim the wallpaper according to your measurements. You can also use a sponge to remove any excess paste, but avoid trimming the wallpaper so close to the corner that it tears. When preparing to hang wallpaper, always consider the thickness of the wallpaper, as it could affect the finished product. When cutting the wallpaper, be sure to measure the distance to the corner and add an additional half-inch to account for the excess.
When hanging wallpaper, make sure to overlap the paper by half-an-inch. The overlap should match the pattern on the adjacent sheet. Always make sure that the overlap is level and plumb. Using a smoothing tool or pattern match set, push the wallpaper inside the corners. Once it has been hung, you can remove the excess paste with a damp sponge. As a rule, you should not overlap wallpaper more than two times.
Paper-backed vinyls
When installing paper-backed vinyl wallpaper, there are a few basic steps you need to follow. To begin, prepare the walls by placing water in a water tray or using a spray bottle filled with water. Water activates the adhesive on the wallpaper. Next, lay the wallpaper in the water tray and fold it so that the adhesive sides of the strip are facing each other. Folding the wallpaper will keep the glue from drying out before the next step.
Then, prime the walls and roll the paper on gently. You can also use a paint roller to apply the paste evenly. After the paper is evenly spread, fold the corners to meet them. This will ensure that the pattern is aligned and not overlapped. When you’re done, hang the paper-backed vinyl wallpaper on the walls. Don’t forget to seam the edges, as this will help the pattern meet evenly.
Once the wall has been prepared, lay the wallpaper over it. Begin with the long edge of the wallpaper. Overlap it by two inches on the baseboard and ceiling. If you’re applying a drop match, make sure that the pattern lines are aligned with the ceiling and baseboard. When the wallpaper is fully adhered to the wall, you’ll be ready to hang it. Then, apply the paste by spreading it evenly across the wall and applying it to the back of the wallpaper. Once the paper is evenly applied, lightly fold it into place.
Applying primer
Before applying primer to hang wallpaper, it is important to clean the wall first. You can use a multi-purpose cleaner and a bucket of warm water to clean the surface. If you do not have a hose or bucket, a sponge will work just as well. Once the wall is clean, you can apply the primer. Before applying the primer, you should choose the type of primer you wish to use. The most common types of primer are acrylic based, alkyd, and PVA.
To determine which paint you need to use, check the type of paint. If the paint is flat or matte, you should apply wallpaper primer to avoid potential damage. Flat or matte paint always needs primer to hang wallpaper. Semi-gloss and glossy paints do not absorb moisture well. Mid-level paint finishes such as eggshell and satin may not need primer. These paint finishes shed water for only a limited amount of time, but can lose their gloss if the paint is old or exposed to UV rays.
If you want to hang wallpaper over an existing paint, apply a primer to seal the surface. Excessive moisture can damage the wall or make the paint underneath the wallpaper soft and brittle. It also prevents the adhesive from soaking into the wall, making it more difficult to remove. Some primers are combined with a sizer. Applying sizing before applying primer is a better option for higher-quality wallpaper.
When you apply primer to hang wallpaper, remember that it is not the wallpaper itself that needs to be primed before applying it. A primer is not only important for the wallpaper to stick to the wall, it also provides a background for it to adhere to. When applied properly, a primer can make it easier to remove the wallpaper after it has been applied. There are also different types of primers available for different types of wallpaper, and using the right primer can make the difference between a great looking wallpaper and a poor one.
