How to Use a Router Table? Everything You Need to Know

Regarding the type of cut you want to create, you need to select a bit with the appropriate profile. The cutting edge’s profile is its shape.

Bits may range from a straight cutting bit for creating grooves to decorative bits with a guide bearing or pilot bearing, such as ogee and cove. The pilot bearing is aligned with the workpiece’s edge.

It is critical to select a router bit with the correct shank size. The collet holds the shank in position at the end of your bit. What is the collet?  It is the part of the router that keeps the bit in place.

Your router’s shank must fit into the collet. Router collets take either a quarter-inch or half-inch shank. Several routers include removable collets that may accept bits with a quarter-inch shank as well as a half-inch shank.

If you have an option, you should choose the half-inch bit. In comparison to quarter-inch bits, half-inch bits cause less vibration and create smoother cuts.

Before altering the bit, make sure you unplug the router.

Pull the bit out about an eighth of an inch and tighten the collet with your fingers after inserting the bit until the cutting edge meets the collet. It is critical to provide a one-eighth-inch gap between the collet and the bit.

As the locking nut is adjusted, the collet pulls the bit inside. If your cutter is in contact with the collect, the bit may not entirely tighten, implying that the router bit might come loose and shoot out. This is quite risky.

Router bits get quite hot very rapidly. Expansion is caused by heat. There is also room for expansion between the collet and the bit.

Tighten the locking nut of the collet with a wrench.

After step two, you need to adjust the bit’s height, which refers to how much of the bit is visible or how much of the bit is going to cut the material.

The height of the bit can be adjusted in a number of ways. You can alter the bit’s height using the router’s depth settings or a router lift.

– Combination Squares – A combination square is one of the simplest and most cost-effective techniques to set the height of your router bit. Lower or raise the bit to the appropriate height by placing the combination square adjacent to it.
– Gauge Blocks — Besides the bit, the gauge blocks are piled. The bit is then elevated until it comes into contact with the gauge block.
– Digital Gauge – A digital gauge enables you to accurately position the bit.

The gap across the bit or the opening in your table can snag the edges of workpiece material. To close the gap, specific router tables feature rings that may be inserted.

This opening in the fence may potentially snag the edges of workpieces, and the distance can be narrowed by adjusting split-style fencing. A split-style fence must be adjusted to the point where it nearly touches the bit.

How do you square the fence on your router table? In fact, for most cuts, the router fence does not need to be perfectly parallel to your bit. When using a miter saw or a table saw, the fence should always be parallel to the blade.

The difference between a flat blade and a round bit is the blade shape. The crucial thing is to place the fence at the correct distance from the bit, and the bit takes care of the rest.

Hence, the type of bit you use determines how you set the fence.

Before cutting the parts for your project, you must always test your setup on some extra wood. This way, you can be sure that everything is in order.